TU VPN

Perma-Link

Modifying server.config file for different VPN Servers and using different Protocols

The Server.config file can be explained as follow.

client      
dev tun  # Device Type Tunnel
proto udp   # currently using udp protocol you can change this to tcp but tcp runs on 443 port so if you change this option you have to change the port on below lines.

remote xxxxx.tuvpn.com 1194  # This line has two Parameters Number one. NAME of the server it is trying to connect Two the Port. As you will be aware of the ServerName or IP we assigned to you this will always remain the same. The Second parameter which is blank field after the server name has two options only 443 or 1194. If you want to run udp you should put 1194 and if you want to use TCP than put 443.

reneg-sec 172800 # The time requires to recheck the validity of the Certificate
resolv-retry infinite # This parameter tells the OpenVPN client to try resolving each remote DNS name for mentioned seconds before moving on to the next server.
nobind # bind to an ip or not. We recommend you to keep nobind here
persist-key
persist-tun
route-method exe
route-delay 2 # Route delay after connection. Dont Increase too much
ca ca.crt   # main certificate name found in the directory
cert usuario.crt
key usuario.key
ns-cert-type server # Certificate Type Server based
tls-auth ta.key 1  # Handshake TLS-AUTH Key. found in the same directory
comp-lzo  # Compression Method. default Compression method used by open VPN is lzo
verb 3      # Verbosity Level during connection, You can set it upto 8
auth-user-pass  # authentication through Password
inactive 86400 # the time your session will be disconnected after being idle.